Console House CSK 2 Mode Manual de usuario descargar pdf (Pagina 51)

8. Service Procedure

8.5.2 Fixing the new tube head

• Take the HV-Tank and fix it to the clamp using the following sequence:-

• Using 2.5mm allen key & 5.5mm nut driver fix 3 Hex. Soc. head cap screws(M3X16) with M3 plain

washers & M3 nuts (at the locations 9 to 11 as in Figure 85 ) such that the screw along with M3 plain

washer should be inserted from bottom and nut along with M3 plain washer should be on the top of

the HV Tank.

• Fix 5 button head screws(M3X6) using 2mm allen key(at the locations 1 to 5 as in Figure 85 ).

• Fix 3 Hex. Soc. Head cap screws(M3X6) on the top of the clamp near Tube head arm at the locations

(6 to 8 as in Figure 85 ) using 2.5 mm Allen key.

• Route the INV power cable as shown in the Figure 84 and connect it to the sealing board 3 pin con-

nector (Pin 1 & 3). Hold the connector firmly while tightening the terminal screws. Using a 2.5mm al-

len key connect the GND ring terminal of the INV cable to the nearest control board fixing screw(M3x4

HSHC) as shown in the Figure 84 .

• Route the communication cable and connect it to the J4 connector of the control board as shown in

Figure 84 and using a 2.5mm allen key connect the GND ring terminal of the communication cable

to the nearest control board fixing screw(M3x4 HSHC) as shown in the Figure 84 .

• Fix the scissor-arm grounding cable on the control board along with sealing board grounding cable

with M3X6 Hex. Socket Head cap screw using 2.5mm Allen key as shown in Figure 84 .

• Using cable ties(100mm length or 50mm length is enough) ties the cables on the HV Tank. Tighten &

cut the extra length of cable ties using a cable tie cutter.

• Execute the steps “8.2.2.4 Tube Head Covers Fixing:”.

• Perform “5.6 Ground Connection Check:”.

• Perform "5.9 Base unit cover fixing:".

• Perform “5.12 Power On Check:”.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 67 68

Sin comentarios

Console House CSK 2 Mode Manual de usuario Pagina 51