Console House 10 Mode Instrucciones de operaciones descargar pdf (Pagina 107)

Time Clocks 2 and 3 is entered into the system and set for time and

dates exactly like Time Clock 1.

The system automatically calculates the time of sunrise and sunset

each day. Sunrise/sunset can be specified as the time a scheduling

command is executed, as an enable/disable time, or as a darkness

conditional on a scheduling command or event button.

To enable the system to properly calculate sunrise and sunset times,

latitude, longitude, and time zone must be set up during installation.

These items should be set to the proper values for the location where

the Omni is installed. The latitude and longitude for a particular

location may be obtained from an almanac or map of the area. These

values should be entered to the nearest degree.

The value entered for the time zone is the number of hours difference

between local standard time at the Omni location and Greenwich

Mean Time. The following values should be used for the standard

time zones in North America:

ZONE

NAME

4 ATLANTIC

5 EASTERN

6 CENTRAL

7 MOUNTAIN

8 PACIFIC

9 YUKON

10 ALASKA-HAWAII

11 BERING

The value specified for longitude may be adjusted to correct for areas,

such as Nova Scotia, where the local time differs from Greenwich

Mean Time by a non-hourly amount. The calculated time of

sunrise/sunset will change by four minutes for every degree change in

longitude. To cause the calculated sunrise/sunset to occur later, enter

a larger value for longitude. Enter a smaller value for longitude to

cause the time to occur earlier.

Latitude, Longitude,

Time Zone

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 135 136

Sin comentarios

Console House 10 Mode Instrucciones de operaciones Pagina 107