Console House 10 Mode Instrucciones de operaciones descargar pdf (Pagina 26)

As the four-digit code is entered, "X" characters are echoed after the

"ENTER CODE:" prompt.

If the Master code or a valid code is entered, the console will beep one

time and Area 2 will be disarmed.

Even if Auto Bypass is enabled, the system will not arm another area

if any zones in that area are not ready. If any zone in Area 2 is not

ready (open), after you enter the code, the console will beep three

times and display "AREA 2" on the top line, and "ZONE NOT

READY" on the bottom line.

AREA 2

ZONE NOT READY #=RETRY

In order to arm Area 2 from a console in Area 1, you must first secure

or Bypass any zones in Area 2 that are not ready. Pressing the # key

will retry the arming process.

To Bypass or Restore a zone in Area 2 from a console in Area 1, or

viceversa, it is first necessary to "go to" that area.

From the security menu, press the # (GOTO) key on the console

keypad.

AREA:

ENTER AREA

↓

The Area number can be entered followed by the ' # ' key, or use the

arrow keys to scroll through a list of areas. Once the area is selected,

you are prompted to enter your code:

GOTO AREA 2

ENTER CODE

The console (AREA 1) will now be temporarily assigned to the

selected area (AREA 2) if a valid code for that area (AREA 2) is

entered. All security and control commands will now operate on the

selected area (AREA 2), just as if you were physically at a console

GOTO Area

26 Omni Owner's Manual

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 135 136

Sin comentarios

Console House 10 Mode Instrucciones de operaciones Pagina 26